Water leak detection kit with 1/2 BSP WRAS approved motor actuated ball valve.

Description

Water leak detection system with Controller and 1/2 BSP Isolating WRAS Ball Valve ABVMSA.

Will detect the slightest water leak, then close the valve and sound an alarm. Easy to install where water leak is a concern, simply install ball valve and place controller with brass contacts onto floor at lowest point for total piece of mind 24/7.

Controller:
Control buttons: Power ON/OFF, Valve Open and Valve Closed.
Led indication for power and valve position.
Includes low battery warning alarm. If batteries not changed within 8 hours will close the valve. (Supplied with 2x Varta 1.5v LR6 AA Alkaline Long Life batteries that will at least 12 months).
Moisture proof to extend battery life
1 meter cable with waterproof connector
Power consumption: (NB 1 Amp = 1,000,000 microamps or 1,000,000uA)
When switched off 2.1uA or 2.1 microamps
When switched monitoring 6.7uA or 6.7 microamps
When opening or closing ball valve 220uA or 220 microamps.

Actuator:
Cycle life: 100,000 open/close
Power: 300 milliamps when moving, 0.015milliamps when monitoring.
Open or close time: 5 seconds
Protection: IP67
Temperature: -15°C to +50°C ambient.
Voltage: 3vDC
Includes: visual position indication.

Ball Valve:
WRAS approved certificate number 2010303
Port: 1/2\ BSP female thread, option NPT thread
Bore: 15mm
Body: 304 stainless steel
Pressure: 0 to 10 Bar
Seals: PTFE + EPDM (WRAS Approved)
Temperature: -15°C to +100°C.
Media: water

Features:

Can detect the slightest water leak, then closes the valve and sounds an Alarm.
Low battery Alarm, valve closes 8 hours later if batteries not replaced. (LED 1+2 will flash)

Controller Buttons and LED:
Power ON (Button + LED 1)
Valve Open (Button + LED 2)
Valve Closed (Button + LED 3)

Controller is water and moisture proof to extend battery life

Easy to install, total piece of mind 24/7 at home or away.

Instructions:

Install valve where water leak is a concern

Install AA batteries (If required) into controller (will need small Phillips H1 screwdriver) + connect cables

Place controller brass contacts on floor at lowest point

Press power ON/OFF button, power ON LED (1) and Valve Closed LED (3) will light up.

Press Valve Open (middle) button, LED (2) Green will flash whilst the valve is opening.

LED’s 1+2+3 will flash when valve open and system in leak detecting mode.

Destruction Test.
On the 26th November 2020 at around 10.40am we connected an ABVM 1/2 BSP dry mini ball valve with 9-24vACDC failsafe closed actuator to our SVDT22 (digital cycle timer), and set this for 1 cycle every 60 seconds (30 sec power ON Open then 30 Sec power off to Close) 24/7 all day all night non-stop. (except holidays)

As of 31st May 2023 the valve has opened and closed, 1,311,280 times and still opening and closing perfectly.

Technical Specification