More 2 Air + Inert Gas Valves 2/2 Latching

Valve / Product Type

Motor Actuated

Solenoid

Valves controlled by electrical signal via a solenoid or electro magnet.

Port Size

3/8 thread

valves with 3/8 inch threaded ports

1/2 thread

valves with 1/2 inch threaded ports

3/4 thread

valves with 3/4 inch threaded ports

1 thread

valves with 1 inch threaded ports

11/4 thread

valves with 11/4 inch threaded ports

11/2 thread

valves with 11/2 inch threaded ports

2 thread

valves with 2 inch threaded ports

Media

Body Material

Brass

Stainless Steel

Function

2/2 Normally Closed

2 ports (inlet/outlet) with 2 positions (Open/Closed) - valve stays closed (Failsafe) requires power to open

2/2 Normally Open

2 ports (inlet/outlet) with 2 positions (Open/Closed) - valve stays open (Failsafe) requires power to close

2/2 Latching

2 ports (inlet/outlet) with 2 positions (Open/Closed) - short power pulse valve stays open - reverse power pulse valve stays closed

Power Open/Power Close

Valve requires power to open and power to close, no power valves stays in position.

Pressure Maximum

Seals

EPDM

EPDM (Ethylene Propylene Diene Monomer) - known as Ethylene Propylene terpolymer, Buna-AP, Dutral, Polysar-EDM, Royalene, Vistalon, Keltan, Epcar, Nordel or Epsyn). Good for hot and drinking water, Steam, Freon refrigerant gas and Air -40°C to +120°C (+150°C steam) Poor resistance to oils + fuels

FKM (Viton)

FKM Fluoro elastomer (Fluorocarbon) Viton® Dupont registered, known as Tecnoflon, Fluorel, Dai-El. Good for hot water, acid, alkali, oils, hydrocarbons and salt solutions, many aggressive chemicals, diluted acids, weak alkali's, mineral oils, aliphatic and aromatic hydrocarbons, chlorinated hydrocarbons, sunlight and ozone. -26°C to +205°C. Poor resistance to Ketone's and Acetone.

HNBR

HNBR (Hydrogenated Nitrile Butadine Rubber) also known as Therban, Zetpol or Tornac). Good for motor oils, sour gas, amine oil mixtures, oxidised fuels, lubricating oils, mineral based hydraulic oil, animal and vegetable oil, diesel fuel, ozone, dilute acids and bases, new bio-oils, H2S Hydrogen Sulphide and C02 carbon dioxide. -40°C to +150°C. Poor for concentrated alkali's, esters, alkyl phosphate, ethers, halogenated solvents, ketone's, halogenated hydrocarbons, solvents and flames.

NBR

NBR (Nitrile Buna Rubber) known as Nitrile Butadine, Buna-N, Hycar, Chemigum, Butakon, Breaon, Butacril, Paracil, Nipol, Perbunan, Krynac or Europrene-N. Good for Aliphatic Hydrocarbons, Petroleum, Fuels, Mineral Oil, Vegetable and Hydraulic Oil, Alcohol and many Acids. -35°C to +100°C. Poor for Ozone, Acetone, Methyl ethyl Ketone, Chlorinated Hydrocarbons, Ethers and Esters.

PTFE (Teflon)

PTFE (Polytetrafluoroethylene) also known as Teflon® Dupont registered. Excellent resistance to almost every fluid or gas. -200°C to +230°C

Voltage

3vDC

3 volts Direct Current for 2x 1.5v AA batteries

6vDC

6 volts Direct Current

12vDC

12 volts Direct Current

24vDC

24 volts Direct Current

24vAC

24 volts 50/60Hz Alternating Current

110vAC

110 volts 50/60Hz Alternating Current

230VAC

230 volts 50/60Hz Alternating Current

Approvals

IP54

Dust protected and protected against splashing water

IP65

Dust tight and protected against water jets

IP67

Dust protected and protected against immersion in water

CSA

CSA approval certifies products for safety and performance, conducted by the Canadian Standards Association.

UL

UL (Underwriters Laboratories) approval indicates that a product has met safety standards set by UL for electrical devices and components.

WRAS

WRAS approval ensures water fittings meet UK water regulations, safeguarding public health by preventing contamination, waste, and misuse of water supplies.

Orifice

15mm

Valve orifice or sealing face with diameter 15mm

20mm

Valve orifice or sealing face with diameter 20mm

25mm

Valve orifice or sealing face with diameter 25mm

35mm

Valve orifice or sealing face with diameter 35mm

45mm

Valve orifice or sealing face with diameter 45mm

50mm

Valve orifice or sealing face with diameter 50mm

Operation

Direct Acting

Directly controls flow without external pressure assistance operates from vacuum upwards.

Pressure Assisted

Operate via pilot pressure control and require a minimum pressure difference between inlet and outlet from 0.5 Bar.

Options required

Anti Water Hammer

Prevents or reduces water hammer caused by sudden changes in fast moving fluid flow.

Bi-Directional Flow

Can control flow in both directions

Degreased

Oil and grease removed typically for oxygen or paint spray use.

Manual Override

A facility to manually move the valve into the fully actuated position via a button, lever or key.

Position Feedback Closed

The valve is equipped with an additional volt free electrical switch that is triggered when the valve is mechanically closed.

Position Feedback Open+Closed

The valve is equipped with two additional volt free electrical switches that are triggered when the valve is mechanically closed or open position.

Position indication Visual

The valve is equipped with clear cover or dome under which an arrow or flag can be seen to confirm either the open and or closed position of the valve.

Shading Ring - Silver

The copper shading ring in the solenoid tube has been replaced with silver. Typically used for RO water and aggressive media applications.

Shading Ring - without

The copper shading ring in the solenoid tube has been removed, for DC voltages only and typically for aggressive media applications.

Only Show Items In Stock

Hide spare parts

More 2 Air + Inert Gas Valves 2/2 Latching

Filters

91 IN STOCK

2 IN STOCK

1 IN STOCK

43 IN STOCK

11 IN STOCK